| 环氧砂浆地坪漆施工地面要求 |
| 添加时间：2018/6/28 17:23:29 浏览次数： |
| 环氧砂浆地坪漆施工地面要求 Construction ground requirements for epoxy mortar floor lacquer 1、水泥基面牢固、结实、不起壳，杜绝砂浆起壳现象，最好混凝土层与砂浆找平层一起浇注；如果先捣混凝土层，则要求砂浆层的厚度不低于4cm，叉车道则要求更厚一些。 1, cement base solid, strong, not shell, stop the mortar shell phenomenon, the best concrete layer and mortar leveling layer together; if first rammed concrete layer, the thickness of the mortar layer is not less than 4cm, forklift road requires a bit thicker. 2.要求表面不起砂，硬度好，没有水泥粉化现象。要求A、优质水泥。 B、新倒水泥砂浆层要充分保养 2., it is required that the surface can not be sanding, with good hardness and no cement pulverization. A and high quality cement are required. B, new cement mortar layer should be fully maintained 3.水泥基面平坦、无凸凹不平、蜂窝麻面、水泥疙瘩。 3. cement flat surface, no convex concave uneven, honeycomb hemp, cement pimple. 4.要求地面平整性不大于涂装要求厚度（用3 米直尺平靠）； 4. requirements of the ground roughness is not greater than the thickness of the coating requirements (with 3 meters ruler). 5.表面干燥，含水量小于6,保持地面干燥无油污,切记水泥地面保养期过后进场施工前5天,不能用水冲洗或拖把拖地. 5. surface dry, moisture content is less than 6, keep the ground dry and oil-free, remember that 5 days before the cement floor maintenance period, it is not allowed to wash or mop the floor with water. 6.地坪表面的PH值应在6.0~8.0 6. the pH value of the surface of the floor should be at 6.0~8.0 7.地面无油污、其他油漆、乳胶漆、泡泡糖等残渣；坡度应符合设计要求，允许偏差值为坡度的2%，并且不大于30mm。 7. the ground without oil, other paint, latex paint, bubble sugar and other residue, the slope should meet the design requirements, the deviation is allowed to be 2% of the slope, and not more than 30mm. |
| 上一页 环氧砂浆地坪应用领域 |
| 下一页 环氧砂浆地坪基面处理 |
Copyright © 技术支持：遨游网络