环氧砂浆地坪涂料施工工艺_新闻动态_环氧砂浆地坪,环氧树脂砂浆地坪,环氧砂浆地面施工-保定厂家价格

新闻动态

当前位置：网站首页 > 新闻动态 > 详细信息

环氧砂浆地坪涂料施工工艺

添加时间：2019/2/18 13:57:46 浏览次数：

1底漆施工：
Primer construction:
将地表封闭，让底漆充分渗透地面，增强附着力，促使面涂平整光滑。在底漆施工前应进行地面含水率的测定，如果含水率高于5%，则应进行断水处理或地面应再保养，达到含水率要求后再施工。

Close the surface, let the primer penetrate into the surface, enhance the adhesion, and make the surface smooth and smooth. Before the primer construction, the ground moisture content should be www.yanglaoyuant.com.cnwww.diandongment.com.cnwww.taiyuanbanjia.com.cnwww.gonglujiemu

ju.cnwww.turangxiufuu.cnwww.yanglaoyuand.cnmeasured. If the water content is higher than 5%, the water cut-off treatment or ground maintenance should be carried out, and the construction should be done after meeting the water content requirement.

底漆施工时将材料按比例充分搅拌均匀，用滚涂或用刮片刮涂于素地，要均匀有光泽，不均匀处理进行第二次补涂。一般24小时后可做中涂。
When primer is applied, the material is fully stirred in proportion and evenly coated on plain ground by rolling or scraping. The primer should be uniform and glossy, and the non-uniform treatment should be applied for the second time. Usually 24 hours later, it can be used as medium coating.
2刮环氧砂浆：
2 scraping epoxy mortar:
用中涂主剂、固化剂、石英砂、石英粉搅拌均匀即成环氧砂浆。用刮刀满刮地坪，达到规定厚度（可增加地坪厚度和抗冲击性，环氧砂浆颜色与面漆颜色同）。
Epoxy mortar is prepared by mixing medium coating agent, curing agent, quartz sand and quartz powder evenly. Scraper is used to scrape the floor to achieve the specified thickness (which can increase the floor thickness and impact resistance, and the color of epoxy mortar is the same as that of topcoat).
3批刮腻子：
Three batches of putty scraping:
砂浆层干燥后，打磨除尘。用环氧漆混合石英粉搅拌均匀即为环氧腻子，用刮刀满刮两道，局部视需要进行补刮。
After the mortar layer is dried, the dust is removed by grinding. Mixing quartz powder with epoxy paint is epoxy putty. Scraping two rounds with a scraper can be done locally as needed.
4打磨吸尘：
4. Grinding and Vacuum Cleaning:
待腻子干躁后，局部腻子进行补刮，用细砂皮整体打磨地坪，彻底消除刀痕并吸尘。
When the putty is dry and restless, the local putty is scraped and the whole floor is polished with fine sand skin to completely eliminate knife marks and dust.
5涂刷色漆：
5 Paint paint:
用滚筒蘸调配的环氧漆满涂一遍，待干躁后修补缺陷并打磨除尘。
Use the epoxy paint dipped in the drum to coat it all over again. After drying, repair the defect and grind the dust.
6面涂施工：
6 surface coating construction:
待色漆干燥后用长毛滚筒蘸清漆满涂一遍以上。
After the paint is dried, dip it in varnish with long wool drum and coat it more than once.
7施工次数：
7 construction times:
地面基础打磨一次、滚涂底漆一次、中涂刮砂两次、面涂刮腻子一次、滚涂面漆一次，共计六次。
Ground foundation is polished once, primer is rolled once, sand is scratched twice, putty is scratched on the surface, and finish is rolled once, totally six times.

上一页砂浆地坪物理特性

下一页透水地坪施工步骤