| 环氧防静电地坪验收标准 |
| 添加时间：2018/7/23 17:37:49 浏览次数： |
| 环氧防静电地坪验收标准 Acceptance standard for epoxy antistatic floor 1、环境温度为25℃时，施工后2-3天应达到实干，即硬度达到完成固化的80%左右； 1. When the ambient temperature is 25 C, the hardness should reach 80% after 2-3 days. 2、表面不能出现发粘现象； 2, there is no stickiness on the surface. 3、气泡：平涂型、砂浆型无气泡，自流平允许1个小气泡/10平方米； 3. Bubbles: No bubbles in plain coated and mortar molds. Self-leveling allows one small bubble/10 square meters. 4、流平性好，无镘刀痕，大面积接口处基本平整; 4. Good leveling, no trowel mark, large area interface is basically flat; 5、无浮色发花，颜色均匀一致，大面积接口处允许有极不明显的色差； 5. No floating hair, uniform color, large area interface allows very inconspicuous color difference; 6、无粗杂质，但允许有空气中的浮尘掉落在造成的极小缺陷； 6. No coarse impurities, but allowed to fall in the air dust caused by the smallest defects; 7、地坪表面应平整平滑，光泽度应达到设计要求（高光泽≥90、有光≥70、半光50～70），平涂型为有光、水性为半光～无光； 7, the surface of the floor should be smooth and smooth, and the gloss should meet the design requirements (high luster more than 90, light more than 70, half light 50~70), flat coating type is light and water is half light to no light. 8、桔皮、砂浆防滑面效果应很明显。 8. The effect of orange peel and mortar against sliding surface should be obvious. |
| 上一页 环氧砂浆地坪应用领域 |
| 下一页 环氧砂浆地坪应用领域 |
Copyright © 技术支持：遨游网络