环氧地坪环氧面涂层
Epoxy floor coating
1、施工前需保持干净，如有杂物粘附需清除；
1. Before construction, it should be kept clean, and if there is any adhesion, it should be removed;
2、将面涂材料的B组份先搅拌均匀；再加入固化剂混合，充分搅拌；
2. First, mix component B of the surface coating material evenly, then add curing agent to mix and fully stir;
3、使用辊筒将材料均匀涂布；
3. The material is evenly coated with a roller;
4、第一遍涂层干固后，再施工第二次面涂层。
4. After the first coat is dry, the second coat shall be applied.
5、自流平面涂用镘刀刮镘一遍
5. The self flowing surface coating shall be troweled with a trowel
6、注意先后施工交接处的处理；涂层要求均匀，无流挂。
6. Attention should be paid to the treatment of the joint of construction successively; the coating should be uniform without sagging.