环氧防静电地坪验收标准
Acceptance standard for epoxy antistatic floor
1、环境温度为25℃时，施工后2-3天应达到实干，即硬度达到完成固化的80%左右；
1. When the ambient temperature is 25 C, the hardness should reach 80% after 2-3 days.
2、表面不能出现发粘现象；
2, there is no stickiness on the surface.
3、气泡：平涂型、砂浆型无气泡，自流平允许1个小气泡/10平方米；
3. Bubbles: No bubbles in plain coated and mortar molds. Self-leveling allows one small bubble/10 square meters.
4、流平性好，无镘刀痕，大面积接口处基本平整;
4. Good leveling, no trowel mark, large area interface is basically flat;
5、无浮色发花，颜色均匀一致，大面积接口处允许有极不明显的色差；
5. No floating hair, uniform color, large area interface allows very inconspicuous color difference;
6、无粗杂质，但允许有空气中的浮尘掉落在造成的极小缺陷；
6. No coarse impurities, but allowed to fall in the air dust caused by the smallest defects;
7、地坪表面应平整平滑，光泽度应达到设计要求（高光泽≥90、有光≥70、半光50～70），平涂型为有光、水性为半光～无光；
7, the surface of the floor should be smooth and smooth, and the gloss should meet the design requirements (high luster more than 90, light more than 70, half light 50~70), flat coating type is light and water is half light to no light.
8、桔皮、砂浆防滑面效果应很明显。
8. The effect of orange peel and mortar against sliding surface should be obvious.